Rounds 6–9: Ch 1. 30 SC around. Join. (30 sts)
Round 10:Ch 1. . Repeat once more. Join. (26 sts)
Round 11:Ch 1. . Repeat once more. Join. (24 sts)
Round 12:Ch 1. . Repeat once more. Join. (20 sts)
Round 13: Ch 1. 20 SC around. Join. (20 sts)
Round 14:Ch 1. . Repeat once more. Join. (24 sts)
Round 15: Ch 1. 24 SC around. Join. (24 sts)
Round 16:Ch 1. . Repeat once more. Join. (28 sts)
Rounds 17–21: Ch 1. 28 SC around. Join. (28 sts)
Finish: Fasten off using an invisible join to leave a clean edge. Hide the yarn tail inside.
4. Arms (White Yarn — Make 2)
Round 1: Start with a Magic Ring. Work 6 SC into the ring. (6 sts)
Round 2:Ch 1. . Repeat 3 times total. Join. (9 sts)
Rounds 3–4: Ch 1. 9 SC around. Join. (9 sts)
Finish: Fasten off with an invisible join, leaving a long tail for sewing if preferred, or hide the tail if gluing.
5. Hat (Red or Green Yarn)
Round 1: Magic Ring. Work 4 SC into the ring. (4 sts)
Round 2: Ch 1. 2 SC in each stitch. Join. (8 sts)
Round 3:Ch 1. . Repeat 4 times. Join. (12 sts)
Round 4:Ch 1. . Repeat 4 times. Join. (16 sts)
Round 5:Ch 1. . Repeat 4 times. Join. (20 sts)
Finish: Fasten off with an invisible join.
6. Accessories (Yellow for Cheeks, Brown for Buttons)
The cheeks and buttons are made using the same simple pattern:
Round 1: Magic Ring. Work 5 SC into the ring.
Finish: Fasten off with an invisible join.
Make 2 Yellow Cheeks and 2 Brown Buttons.
7. Assembly and Finishing
Safety Eyes: Insert the 5mm safety eyes between Rounds 6 and 7 of the head, leaving about 2 stitches of space between them.
Embroidery:
Nose: Use red yarn to stitch a tiny horizontal line centered just below the eyes.
Smile: Use a single strand of red yarn to embroider a wide, cheerful curve.
Cheeks: Apply glue to the back of the yellow circles and place them on the face, slightly lower than the eyes and to the sides.
Arms: Glue or sew the arms to the sides of the body at the “shoulder” area (around Round 16-17).
Hat: Glue the hat onto the head at a slight jaunty angle. Ensure the slip stitch seam is facing the back. Glue the 1cm white pom-pom to the tip of the hat.
Buttons: Glue the brown buttons vertically down the center of the snowman’s belly.
Your little snowman is now finished! You can add a jump ring and a keychain clasp to the top of the hat to make it a perfect winter accessory.
Category: Amigurumi
