Once you reach the end of Round 7, work one final slip stitch into the next stitch to smooth out the edge. Cut the yarn, leaving a 6-inch tail. Pull the yarn tail completely through the loop. Use your tapestry needle to pull the end behind the stitches of the previous round to create a seamless finish, then knot it securely on the back of the coaster and trim the excess.
Care & Washing Instructions
- Machine wash on a gentle cycle in cold water using a mild detergent to preserve the cotton fibers.
- Lay the coasters flat on a clean towel to dry, reshaping them with your hands while damp to ensure they remain perfectly circular.
- If the coasters become slightly warped after many uses, lightly steam them with an iron set to the cotton/linen setting while holding them flat on an ironing board.
Pro Tips & Common Mistakes to Avoid
Maintaining consistent tension is the most important factor in keeping your coasters flat. If your coaster begins to cup or bowl, your tension is likely too tight; try going up half a hook size. Conversely, if the edges ruffle or wave, your tension is too loose, or you are adding too many stitches. Always move your stitch marker to the first stitch of every new round to avoid losing your place in the repeat. When weaving in your ends, run the needle through the back loops of the stitches on the reverse side of the work rather than through the front, which keeps the face of the coaster looking clean and professional. To adjust the size, simply add or subtract rounds using the same increase logic: add 6 stitches per round. Keep in mind that larger coasters will require significantly more yarn.
Frequently Asked Questions
Can I use a larger hook for this pattern?
Using a larger hook will result in a larger, looser coaster. While this is acceptable, be aware that the gaps between stitches will be more pronounced, which makes the coaster less effective at blocking moisture from reaching your table surface.
Why does my coaster look like a bowl instead of a flat circle?
If your project is curling upward, your stitches are likely too tight, or you are failing to complete the required number of increases. Ensure you are working exactly 6 increases in every round to maintain a flat surface.
Is it possible to sell items made from this pattern?
You are welcome to sell finished items created from this pattern. However, you must credit the designer and use your own photographs to represent your work.
Can I use variegated yarn for these coasters?
Variegated or self-striping yarn works well for this pattern, as it creates a spiral color effect. Since this is a simple design, the yarn will provide all the visual interest without requiring difficult stitch patterns.
Pin for later!
A finished handmade throw brings warmth to any living room, especially when the stitches look this crisp and defined. You might experiment with an ombre effect by swapping colors every four rows or try using a wool-blend yarn for extra weight if you prefer a heavier cover. Snap a photo of your finished work and share it on Instagram or Pinterest to show off your progress. Please browse my blog archives for more free patterns if you enjoyed this project and want to find your next handmade challenge.
PinterestFacebookWhatsAppFlipboardShare
