- Green yarn (base and leaves)
- Red and white yarn (for flower appliqués)
- Crochet hook suited to your yarn and cable size
- USB cable
- Scissors
- Silicone glue (for attaching flowers)
- Yarn needle (for weaving ends, optional)
Size & Measurements
- Adjustable to any USB cable length
- Each leaf: approximately 2–3 cm
- Each flower: approximately 1–2 cm
- Cable fully encased and embellished throughout
Gauge & Stitch Details
- Gauge is not critical; focus on tight, even coverage.
- The key stitches: single crochet, chain, double crochet, slip stitch
- Incorporates Tunisian crochet and basic flower construction
Crochet Abbreviations
- ch: chain
- sc: single crochet
- dc: double crochet
- sl st: slip stitch
Special Stitch Guide
- Tunisian Crochet Loop: Insert hook in chain, yarn over, pull up a loop, keep all loops on hook.
- Tunisian Return Pass: Yarn over, pull through 2 loops, then (yarn over, pull through 3 loops) repeatedly until 1 loop remains.
- Flower Petal: ch 3, 3 dc, ch 3, sl st into ring.
Complete Crochet Patter 1: Base Coverage
- Attach green yarn to the cable with a slip knot.
- Work 18 sc snugly around the cable, hiding the tail as you go. Save
 2: Tunisian Crochet Leaf Pattern
- For each leaf: ch 7.
- Starting in the second chain from the hook:
- Yarn over, pull up a loop in each of the next 6 chains, making each loop a bit looser for a wider leaf form.
- Return Pass:
- Yarn over and pull through 2 loops, then yarn over and pull through 3 loops consecutively until 1 loop remains.
- Second Side:
- Rotate to work along other side of the starting chain, repeat process to create a symmetrical leaf. Save
- Finish Leaf:
- ch 1, then work a line of sl st down the leaf’s center (this creates the stem).
 3: Connecting Leaves
- Resume wrapping the cable with 20 sc to cover the next segment between leaves.
- Repeat the full leaf pattern process as before.
- Continue alternating 20 sc and leaf until the cable length is covered. Save
- Finish final segment with 18 sc.
 4: Flower Appliqué
- For each flower (make 22, alternating red and white):
- ch 5, sl st into first chain to form a ring.
- For each petal (repeat 3 times):
- ch 3, 3 dc into ring, ch 3, sl st into ring. Save
Assembly & Finished Size
- Twist the leaves so they alternate in direction along the cable (one left, one right).
- Using silicone glue, attach one flower between each pair of leaves, holding until set.
- Allow all glued areas to dry fully before using the cable again. Save
Conclusion
This decorative cable cover uses single crochet, Tunisian crochet leaves, and small flower appliqués to create a cheerful, nature-inspired look for any USB cable. By combining careful stitchwork, alternating leaf placement, and colorful flowers, the project ensures both durability and visual appeal. With flexible instructions and basic supplies, the result is a lively cable wrap that’s both protective and eye-catching.
Pin22 Shares
Advertisement
Pages: 1 2
