Lotus Bloom Hanging Toilet Paper Holder Crochet Pattern

Wall

Rnd 11: Ch 1, sc in BLO of each st, join. (60) This turns the edge up into a wall and leaves the front loops of Rnd 10 free for the leaves.

Rnds 12–14: Ch 1, sc in each st, join. (60)

Rnd 15: Change to pink. Ch 1, sc in BLO of each st, join. (60) The front loops of Rnd 14 stay free for the outer petals.

Rnds 16–18: Ch 1, sc in each st, join. (60)

Rnd 19: Ch 1, sc in BLO of each st, join. (60) The front loops of Rnd 18 stay free for the inner petals.

Rnds 20–22: Ch 1, sc in each st, join. (60) Fasten off pink.

Checkpoint: 12 wall rounds, 3 in (7.6 cm) tall. A roll should drop in easily.

Leaf Ring

Turn the pocket upside down. Join green in any free front loop of Rnd 10.

Work 10 Leaves around, each over 6 consecutive front loops. 10 x 6 = 60, so you use every loop exactly once. Join with sl st to the first leaf base and fasten off. (10 leaves)

Outer Petal Tier

Join pink in any free front loop of Rnd 14. Mark this loop as st 1.

Work 10 Petals around, each over 6 front loops (10 x 6 = 60). Join and fasten off. (10 petals) The tips come up to about the rim.

Inner Petal Tier

Count 3 sts to the left of the st directly above st 1 and join pink in the free front loop of Rnd 18 there. This 3-st shift puts each inner petal between two outer petals.

Work 10 Petals around (60 loops). Join and fasten off. (10 petals) The tips stand 1 in (2.5 cm) above the rim.

Pocket checkpoint: 5 in (12.7 cm) across and 4 in (10.2 cm) tall to the inner petal tips, with 30 leaves and petals in total.

Make All Pieces

• Back panel: 1 in green
• Pockets: 3, each with green Rnds 1–14 and leaf ring, and pink Rnds 15–22 and both petal tiers

Layout (panel rows, bottom to top):

Joining

Work the panel border and loop (next section) before you sew anything, because the pockets cover the panel edges once they are attached.

Method: Whipstitch with green yarn and a tapestry needle.

Stitch-to-stitch logic: Each pocket attaches along 12 sts at the back, which is one-fifth of its 60-st circumference. They match the 12 center sts of the panel (sts 2–13), so the outer st on each side stays free. Lift the back petals and leaves forward while you sew.

1. Pocket 1: Sew the 12 back sts of Rnd 11 to sts 2–13 of Row 1. Sew the matching 12 sts of Rnd 22 to sts 2–13 of Row 12.
2. Pocket 2: Sew Rnd 11 to Row 25 and Rnd 22 to Row 36.
3. Pocket 3: Sew Rnd 11 to Row 49 and Rnd 22 to Row 60.
4. Whipstitch the two vertical side lines of each pocket wall to the panel (12 rows to 12 rounds).

Tension: Pull each stitch snug but not tight. The panel should stay flat, without dimples behind the pockets.

Size checkpoint: Pocket rims sit 6 in (15.2 cm) apart. Rows 61–76 show 4 in (10.2 cm) of plain panel above the top pocket.

Border

Border gauge: Along the long sides, work 7 sc for every 8 row-ends. That matches the 14 sts / 16 rows gauge ratio, so the edges don’t ruffle or pull in.

Pick up the green loop left at Row 76 and work down the left side.

Rnd 1:
– Left side: 1 sc in each of the 4 shaping row-ends (Rows 76–73). Then across Rows 72–1, work (1 sc in each of the next 7 row-ends, skip 1) 9 times. That’s 4 + 63 = 67 sc.
– Bottom: Working into the foundation ch, 3 sc in first ch, sc in next 12, 3 sc in last ch. That’s 3 + 12 + 3 = 18 sc. Both bottom corners are counted here and nowhere else.
– Right side: Same as left, in reverse: 63 sc up Rows 1–72, then 4 sc in the shaping row-ends = 67 sc.
– Top: 1 sc in each of the 6 sts of Row 76 = 6 sc.
– Join with sl st to the first sc. Total: 67 + 18 + 67 + 6 = 158 sc.

The top corners get no extra stitches, because the decreases already form a curve.

Hanging loop: Sl st into the next sc (top st 2), ch 16, skip top sts 3–4, and sl st into top st 5. Work 24 sc into the ch-16 space, sl st into top st 5, and fasten off. The loop stands about 2 in (5.1 cm) tall.

Why the math works: 72 straight rows x 7/8 = 63 sc. The bottom edge (12 + 3 + 3) covers 14 sts plus 2 corner turns. The border adds 0.25 in (0.6 cm) to each edge: 4 + 0.5 = 4.5 in (11.4 cm) wide and 19 + 0.5 = 19.5 in (49.5 cm) tall.

Final Blocking

1. Weave in all ends along the wall or panel stitches, going in the same direction as the stitches.
2. Mist the holder lightly with cool water until it is damp but not wet.
3. Lay it flat face up. Pin the panel to 4.5 in (11.4 cm) x 19.5 in (49.5 cm).
4. Put a toilet roll, or a roll wrapped in plastic, inside each pocket to shape the wall into a round.
5. Push the petals outward with your fingers so they flare a little and the tips point up.
6. Let it dry completely, then take out the rolls and unpin.

Final Quality-Control Checklist

• Panel measures 4.5 in (11.4 cm) x 19.5 in (49.5 cm).
• Border has 158 sc with no gaps along the sides.
• Hanging loop is centered and firmly anchored.
• Each pocket has 10 leaves, 10 outer petals and 10 inner petals.
• Inner petals are staggered between the outer ones.
• Pocket rims are 6 in (15.2 cm) apart and level.
• Every roll slides in and out easily.

Troubleshooting

• Base cups or ruffles: Check that each round from 1 to 10 has 6 more sts than the one before. If it does, change hook size.
• Wall flares outward: Rnd 11 must go into the BLO. Working both loops gives you no fold line.
• Petals lean or twist: Make sure you worked Rows 2–4 and 6 in the BLO and that each petal starts in its own 6 loops.
• Petal count comes out at 9 or 11: You skipped or doubled a front loop. Count to 60 before you start each tier.
• Panel edges wave: Keep to 7 sc per 8 row-ends. If they pull in, skip 1 in every 10 instead.
• Pocket sags: Add a second whipstitch line halfway up the wall.
• Holder tilts on the hook: Check that the loop is anchored at top sts 2 and 5, the same distance from each edge.

Care

Hand wash in cool water with mild soap, press out the water in a towel, and dry flat with rolls inside to reshape. Don’t tumble dry.

Final Notes

The sizes all come from one measurement chain. A 60-st base 5 in (12.7 cm) across carries a 3 in (7.6 cm) wall and 10 leaves and 20 petals of 6 sts each. A 14-st panel 4 in (10.2 cm) wide grows to 4.5 in (11.4 cm) once the 158-st border is on. Pockets set 24 rows (6 in / 15.2 cm) apart fill the 19.5 in (49.5 cm) holder. If your first pocket matches gauge, the rest of the holder will come out to these sizes too.

Happy crocheting!